VP44 Information
#31
Yeah i wouldnt spend the money on the HR VP. Im happy with my HO its taking me over 550 with a single turbo so im happy
#32
Hello i had a VP44 pump installed on my 99 dodge its all stock far as the motor it has a holley blue for a lift pump .My point is after this new injection pump was installed when i first start it and put it in drive it will lope for couple sec's and clear out it dont do it all the time and it is a auto anyone have any idea why it does this ? It never did it with the old pump before it went out...
#33
possibly a sheared key way if you are getting white smoke that is likely, it would modify your timing and you might get a p0216 code. Sometimes low stall converters can have drivability at very low RPM and cause stalling or seem like it wants to stall. I have also seen issues with a bad TPS cause similar issues (I have nice ones in stock for less than 1/2 what the dealer charges). Without codes its tough to pin down.
#34
huh ?
---AutoMerged DoublePost---
If that reply was to me im not getting no white smoke or no codes flashin or coming up ? It Acts like i have big injectors in it but i dont ..
---AutoMerged DoublePost---
If that reply was to me im not getting no white smoke or no codes flashin or coming up ? It Acts like i have big injectors in it but i dont ..
Last edited by 01ISX; 11-18-2010 at 02:45 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
justinsbeck
24 Valve 2nd Gen Dodge Cummins 98.5-02
6
01-18-2016 12:15 AM
DeLuzGN
24 Valve 2nd Gen Dodge Cummins 98.5-02
5
03-17-2015 08:08 AM
somarillw
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
12-15-2014 12:00 AM