plate issues
#1
plate issues
ok while i had the pump off the engine i figured no would be the time to go threw it top to bottom. i installed my new 0 fuel plate and noticed the governor arm was riht at the base of the plate, it looked like it had room to slide and not dive under, hopefully. i was wondering were the governow arm should be on the plate and how th adjust the arm, i forgot were the damn adjustments are made
#2
IIRC you want to take the cover off and adjust the left screw. Not sure which way lifts or raises it tho.
But here's a pic of where you adjust it...
I need to do this while I got mine tore down also.
---AutoMerged DoublePost---
Hopefully someone that knows how to do this will post the full how to...
---AutoMerged DoublePost---
i found it! page 2 DM is explaining it
---AutoMerged DoublePost---
turning up a 12v
But here's a pic of where you adjust it...
I need to do this while I got mine tore down also.
---AutoMerged DoublePost---
Hopefully someone that knows how to do this will post the full how to...
---AutoMerged DoublePost---
i found it! page 2 DM is explaining it
---AutoMerged DoublePost---
turning up a 12v
Last edited by Cummins97; 02-22-2009 at 02:02 PM. Reason: Automerged Doublepost
#3
Yeah, its the back of the pump under the cover, there are 3 bolts there, make sure you get the right one ... But from the sounds of it, your arm is right where it should be. On a 0 plate as long as its not diving under you'll be fine. And if its the stock plate re-ground you shouldn't have to adjust it at all.
#9
Thread
Thread Starter
Forum
Replies
Last Post
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
JustAnother_cummins_guy
12 Valve 2nd Gen Dodge Cummins 94-98
4
11-10-2014 09:44 PM