94 12valve going into a 94 f250
#81
Factory bolts go to 125 ft. lbs. If I remember right, the only ones that get less than that are the ones that help hold the rocker pedestals on. Thats the point of overtorqued head bolts, they are torqued more than the factory spec. And my upgraded bolts are at about 130 ft. lbs.
https://www.dieselbombers.com/mighty...ead-bolts.html
I am running a 35/40 hybrid right now, meaning it is an HX35 that has a 60mm 6blade HX40 wheel on the compressor size. Good flow upgrade, but I still just run 30-35 psi as I'm sure drive pressures are out the roof even at 35psi. As quick as I can, I'm going to throw either an S472 or S475 on in a compound setup. Drive pressure (especially coupled with timing) kills HG's but a good compound setup can hold about a 1:1 boost to drive pressure ratio nearly all the way through the boost range.
https://www.dieselbombers.com/mighty...ead-bolts.html
I am running a 35/40 hybrid right now, meaning it is an HX35 that has a 60mm 6blade HX40 wheel on the compressor size. Good flow upgrade, but I still just run 30-35 psi as I'm sure drive pressures are out the roof even at 35psi. As quick as I can, I'm going to throw either an S472 or S475 on in a compound setup. Drive pressure (especially coupled with timing) kills HG's but a good compound setup can hold about a 1:1 boost to drive pressure ratio nearly all the way through the boost range.
#82
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
1
11-23-2015 11:39 AM
1ATony
1A Auto Parts
1
10-29-2015 02:11 PM
Sculpturesylvan
General Diesel Related
0
10-18-2014 10:19 PM