To ppump or not to ppump,that is the question
#11
#12
I seem to recall something about 45 psi. but my memory isn't always the best.
---AutoMerged DoublePost---
Fixed that for ya doc.
Mitusa stands for Made In The USA, for those of you that care.
---AutoMerged DoublePost---
Fixed that for ya doc.
Mitusa stands for Made In The USA, for those of you that care.
Last edited by 00' Quad Cab; 05-03-2008 at 11:19 AM. Reason: Automerged Doublepost
#13
think i can get er' dunn for under 3k?
---AutoMerged DoublePost---
same pump evil
---AutoMerged DoublePost---
Airdog makes a pump,I think it's the same as the 24valve one,different install maybe,I'll call em' monday and see.
---AutoMerged DoublePost---
same pump evil
---AutoMerged DoublePost---
Airdog makes a pump,I think it's the same as the 24valve one,different install maybe,I'll call em' monday and see.
Last edited by Mr.Krabs; 05-03-2008 at 11:46 AM. Reason: Automerged Doublepost
#14
#15
okay,I'll do that,I'm going to go get the truck sunday or monday and check the codes,then most likely order a IP,unless it's the Crank position sensor or something like that.
New baby here,and my wife is on my posterior about trying to figure this stuff out,so most likely go ahead and VP it up.
But going to be gathering up parts for the next time
Still,if anyone has anything to add I'd love to hear it,I'd do this thing now if only I had the time!
---AutoMerged DoublePost---
BTW,you all notice my Bold name,and bombardier title?
This site is the bomb-diggity!
New baby here,and my wife is on my posterior about trying to figure this stuff out,so most likely go ahead and VP it up.
But going to be gathering up parts for the next time
Still,if anyone has anything to add I'd love to hear it,I'd do this thing now if only I had the time!
---AutoMerged DoublePost---
BTW,you all notice my Bold name,and bombardier title?
This site is the bomb-diggity!
Last edited by Mr.Krabs; 05-03-2008 at 02:34 PM. Reason: Automerged Doublepost
The following users liked this post:
Dr. Evil (05-03-2008)
#16
Thread
Thread Starter
Forum
Replies
Last Post