transmission build problem. any help is welcome.
#1
transmission build problem. any help is welcome.
i just got the o.d. section done and went to put it on the transmission and it wont go together. it gets about a half an inch or so away from mating together and thats it. any help is needed. its got a dtt tranny rebuild kit.
---AutoMerged DoublePost---
Fixed it. all i needed was a big brass hammer.
---AutoMerged DoublePost---
Fixed it. all i needed was a big brass hammer.
Last edited by 97cumminskid; 07-31-2011 at 07:43 PM. Reason: Automerged Doublepost
#2
the rear planet and other splined thing the intermediate shaft goes in have to line up, when you put the OD section back together in the press you have to use a special tool to keep them aligned right, if you use a light and look down into the od section you will be able to see what im talking about
Thread
Thread Starter
Forum
Replies
Last Post
burndiesel
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
02-07-2023 01:15 AM
jeremy01995
12 Valve 2nd Gen Dodge Cummins 94-98
1
09-14-2015 06:34 PM