Killer Dowel Pin
#11
11-26-2009, 06:44 PM
The following users liked this post:
bajabomber87 (11-29-2009)
#13
11-27-2009, 10:46 AM
Nope, no need for that.
It's really an easy job, just take your time with it.
For those without air tools, you can get the barring tool from Cummins to keep the motor from rotating while you unbolt the harmonic balancer (damper).
I did mine a few months back, and I also had the updated gear case so the tab wasn't needed.
A little trick that helps is to put the gear cover in the oven for a few minutes, and the new seal in the freezer for a few as well. It makes it a little easier to get that crank seal into the cover when doing so.
Someone once said: "A little physics goes a long way"
It's really an easy job, just take your time with it.
For those without air tools, you can get the barring tool from Cummins to keep the motor from rotating while you unbolt the harmonic balancer (damper).
I did mine a few months back, and I also had the updated gear case so the tab wasn't needed.
A little trick that helps is to put the gear cover in the oven for a few minutes, and the new seal in the freezer for a few as well. It makes it a little easier to get that crank seal into the cover when doing so.
Someone once said: "A little physics goes a long way"
Last edited by DeLuzGN; 11-27-2009 at 10:49 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
08-25-2015 07:10 PM
windage
12 Valve 2nd Gen Dodge Cummins 94-98
7
07-17-2015 12:45 PM
359ci12v
1st Generation Dodge Cummins 89-93
2
04-09-2015 08:24 AM
