Need some help with throttle linkage rod
#11
#13
I just replaced mine, Got them from diesel shop in my town 40 bucks, New rod and lock nuts with 2 new ends. The only thing I dont like is that the new rod is not as big as the new one. old was like 1/4-20 and the new one is alot thinner. I kept the old one which was just bent as a back up.
---AutoMerged DoublePost---
Just looked at picture again and you have a small hyme joint end and what you need is the ball joint. 1 right hand and 1 lefthand.
---AutoMerged DoublePost---
Just looked at picture again and you have a small hyme joint end and what you need is the ball joint. 1 right hand and 1 lefthand.
---AutoMerged DoublePost---
thanks for the pictures Snoot!!! i see what you mean now.
kieron kohlmann - ya thats where i got the part numbers for what ive got now except i went through McMaster-Carr. looks like im gunna be sending em back. only thing that sucks is theres no close cummins dealers around here.
---AutoMerged DoublePost---
wait i just checked and the ones i ordered are the ball joint ends. maybe i got the wrong end design. McMaster-Carr and McMaster-Carr . guess ill just have to go through cummins.
Last edited by Rusty89Cummins; 04-27-2011 at 11:54 PM. Reason: Automerged Doublepost
#14
Use a bolt, the ball on the front just screw out. IF I remember correct its a 8mm wrench on top and a 10mm on the nut on bottom. The one an angle grinder will make quick work.
This thread also has part numbers if you read through it....
https://www.dieselbombers.com/dodge-...ottle-rod.html
This thread also has part numbers if you read through it....
https://www.dieselbombers.com/dodge-...ottle-rod.html
Last edited by RSWORDS; 04-28-2011 at 10:31 AM.
#16
ya thats where i got the numbers from. i think i will just make the ones i have now work so i dont have to pay for shipping to send em back and pay for the same in shipping that id did for the ends in the first place. thanks for all the help guys. i guess i would just recomend buying the ends from cummins in the first place to make things easier.
Thread
Thread Starter
Forum
Replies
Last Post
12vWoodHauler
12 Valve 2nd Gen Dodge Cummins 94-98
1
09-30-2015 07:58 PM
1stgenswap
1st Generation Dodge Cummins 89-93
2
11-03-2014 09:45 PM