Need some help with throttle linkage rod
#1
Need some help with throttle linkage rod
Alright so i bought some new ends for my throttle linkage rod for my pump from McMaster-Carr. I thought they would just snap over the pins like the old ones do but they dont. I though i saw someones setup before on here where it did. Anyone know what i have to do to use them? I was thinking a bolt to replace the pin on the arm on the pump, but i dont know what to do with the other one thats on the bracket thats connected to my throttle cable because its not bolted to it. Any help would be great.
#6
#9
I just replaced mine, Got them from diesel shop in my town 40 bucks, New rod and lock nuts with 2 new ends. The only thing I dont like is that the new rod is not as big as the new one. old was like 1/4-20 and the new one is alot thinner. I kept the old one which was just bent as a back up.
---AutoMerged DoublePost---
Just looked at picture again and you have a small hyme joint end and what you need is the ball joint. 1 right hand and 1 lefthand.
---AutoMerged DoublePost---
Just looked at picture again and you have a small hyme joint end and what you need is the ball joint. 1 right hand and 1 lefthand.
Last edited by fatirishguy; 04-27-2011 at 09:22 PM. Reason: Automerged Doublepost