i was wondering if you could just take the pin out and run it like that in sted of buying the kit to fix it

 

noo do not do that just make a delete kit yourself

 

Peen it - no kit required.

 

what do you meen peen it

 

he means pin it..there is a thread on here somewere.

 

No I mean "peen" it:

peen   
[peen] Show IPA
–noun
1.
a wedgelike, spherical, or other striking end of a hammer head opposite the face.
–verb (used with object)
2.
to enlarge, straighten, or smooth with a peen.
3.
to strengthen (a metal surface) by light hammering or by bombardment with steel ***** or shot.

Three whacks with a center punch around the edge of the hole at 10, 2 and 6 o'clock. Or whatever number and positions you like. Just make it so the KDP can't come out. And no extra parts cobbed up in there to come loose again later, either.

 

thats what i did

 

Solder it in and I'm not talking about using a cheasy iron to do it I mean like brazing it in seen a few like that

 

I just cut a small piece of aluminum and tabbed mine.