How to remove cam (part way)
Thread Starter
|
Site Sponsor
Joined: Apr 2009
Posts: 3,719
Likes: 636
From: Lexington SC
How to remove cam (part way)
As always ~ SAFETY FIRST!!
- Disconnect the Negative cable of your battery system.
- Chock the wheels and set the parking brake.
- Have a known good fire extinguisher close by.
- Have good lighting.
- Have a clean and orderly work area.
- Always exercise good working practice with your tools.
- Use safety goggles, gloves, masks, etc where appropriate.
Remove the dampner
Remove the bolts in gear cover and remove the gear case (note blown seal)
Remove the tap-it cover
align the timing markes
Remove the cam retainer bolts
This is a hard part you have to hold up the tap-its I used a pare of plyers and pulled each one while putting psi on the cam
Rotate and remove the cam tap-it by tap-it and set on floor (standing up an tie to something so it wont fall over)
(More to come)
- Disconnect the Negative cable of your battery system.
- Chock the wheels and set the parking brake.
- Have a known good fire extinguisher close by.
- Have good lighting.
- Have a clean and orderly work area.
- Always exercise good working practice with your tools.
- Use safety goggles, gloves, masks, etc where appropriate.
Remove the dampner
Remove the bolts in gear cover and remove the gear case (note blown seal)
Remove the tap-it cover
align the timing markes
Remove the cam retainer bolts
This is a hard part you have to hold up the tap-its I used a pare of plyers and pulled each one while putting psi on the cam
Rotate and remove the cam tap-it by tap-it and set on floor (standing up an tie to something so it wont fall over)
(More to come)
Thread
Thread Starter
Forum
Replies
Last Post
wolfriver
24 Valve 2nd Gen Dodge Cummins 98.5-02
6
Mar 23, 2016 10:18 PM
Jet A Fuel
Tech Article Submission
0
Jun 5, 2015 03:55 PM
Jet A Fuel
Tech Article Submission
0
Jun 5, 2015 03:28 PM
Diesel Bombers
General Diesel Related
0
Mar 4, 2015 08:20 AM
