Need help 95 7.3
#12
I got a 95 7.3 turbo diesel.
It stopped cranking when got so I replaced IPR orings
Well now it just turns over no crank
Would fire off with ether
Now the wts light stopped working
Tach also
It turns over but won't crank even with ether..
Hpop is full.
One battery was shorted out also.
All fuses are good and swapped relays
It had a TS chip but I took it off to see if would help but no change..
Any help!!!!!
Txt or call 254-366-0315
It stopped cranking when got so I replaced IPR orings
Well now it just turns over no crank
Would fire off with ether
Now the wts light stopped working
Tach also
It turns over but won't crank even with ether..
Hpop is full.
One battery was shorted out also.
All fuses are good and swapped relays
It had a TS chip but I took it off to see if would help but no change..
Any help!!!!!
Txt or call 254-366-0315
Your issue is an electronic one, not a mechanical one. Get a scanner on it (betting it will not comunicate with a dead PCM) and go from there.
#14
Maybe a hard to start, but IPR O rings will have no effect on how the truck cranks.
You do know that the center O ring is always split on the IPR, its that way factory.
Get a scanner on it and go from there.
#16
What I am getting at is Be clear when you are discribing things... Changing IPR o rings will have NO effect on how the truck cranks...0.
That is up to the starter and batterys.
Can bad IPR o rings make the truck hard to start, sure... however without a scanner to check ICP pressures and duty cycle your just pissing money away to put new o rings on.
That is up to the starter and batterys.
Can bad IPR o rings make the truck hard to start, sure... however without a scanner to check ICP pressures and duty cycle your just pissing money away to put new o rings on.
Thread
Thread Starter
Forum
Replies
Last Post
tumble72
Ford 83-94 6.9 and 7.3L General
8
11-27-2014 10:31 PM