No power pulling my trailer
Code 78 - Wastegate Solenoid
Wastegate is working fine. Replaced everything from vacuum pump to the wastegate and all vacuum lines and solenoid. Still flashing that same code.
Wastegate is working fine. Replaced everything from vacuum pump to the wastegate and all vacuum lines and solenoid. Still flashing that same code.
The pigtails have been known to have electrical problems when they get this old-might want to check connections and wiring?
perhaps replace the pigtail with solder and heat shrink if needed?
perhaps replace the pigtail with solder and heat shrink if needed?
my 94 F 250 IDI is showing the same symptoms !
mechanic says IP fuel pressure is good filters changed... fuel and clean oil filter...battery 1 on the drivers side was loose and I tightened it but still no pulling power... 294 000 miles and no smoke, starts up every time and drives almost to 80 mph on the flats...got 7 lbs. of boost which is all the Garrett factory ford turbo will put out. Im just as confused.
mechanic says IP fuel pressure is good filters changed... fuel and clean oil filter...battery 1 on the drivers side was loose and I tightened it but still no pulling power... 294 000 miles and no smoke, starts up every time and drives almost to 80 mph on the flats...got 7 lbs. of boost which is all the Garrett factory ford turbo will put out. Im just as confused.
Thread
Thread Starter
Forum
Replies
Last Post
kmurray
6.7L Performance
7
Mar 27, 2016 08:31 AM
1ATony
1A Auto Parts
1
Oct 29, 2015 02:11 PM
Diesel Bombers
General Diesel Related
0
May 7, 2015 11:50 AM
Diesel Bombers
General Diesel Related
0
May 7, 2015 01:40 AM



