so if you don't minde me asking...how much???

 

it was 475 shipped back for the 5x.14's. including all new horseshoes and injector o rings and all that good stuff. i think he said they would add somewhere around 80 horses on a stock ve pump and around 125 or so on their p pump versions. pm the guys at southern diesel extreme for the exact specs on em though

 

5 months later

bump

 

and whats the reasoning behind the bump? seems like the topic kind of died to me

 

Was hoping for an update

 

smokem did mine (9MM to 7MM) they work great ben running them since christmas

 

I can agree to the bump

I still wanna try and or see some cross pattern spray nozzles in action.. I can prolly afford to be the guinea pig!

 

I'm doing a set of micro-blind nozzles for a certain 14mm VE 1st Gen with triples. I may or may not be doing a few sets of the impinged nozzles, one for a 1st Gen, one for a 2nd Gen.

 

I know this thread is old, but I just wanted to shed some more light on the subject. I have never ran a 6x.0xx injector and I seamed to make pretty decent power. I ran a set of honed 370’s (5x.013) for years. I took them from 317hp to 638hp without touching them. I have also ran different sets of DDP 4’s 66lpm, 72lpm, and 76lpm and with all of them I was over 600hp. Just for giggles I had a set of the original 185’s honed and they measure 5x.010. I never have dynoed them because I thought they would be a little restrictive for the 14mm pump. If I get my hot 12mm pump back I might just put it on with the 185’s and see how it does.

I currently run a set of the biggest 12 valve injectors that Lenny from Dynomite Diesel has ever built. It was kind of an experiment and I am still doing some testing with them. I was not able to do an apples to apples comparison when I dynoed last time because I was having some difficulties with my FASS, and my valet switch. I have not worked on my pickup since about September and I am hoping that I will be able to start tinkering sometime soon. I have a very special project in the works that I would like to finish.


Stomp

 

Do you know the hone size or hydraulic rating? I would be curious to see something in the 5x0.020" 5LPM range with a large sac entrance.