s360sx or s362sx
#22
so 450hp ish? a 60mm charger would be fine for that level. being that your truck is an auto i would stay with as small a turbine housing as you can. a HE351 off of a 04.5-07 5.9 wouldnt be a bad option they are 60/60/9cm or if the 9cm housing gives you drive pressure concerns just do a 35/40 hybrid
#25
#27
he351 is better than the super 40 except for potential drive pressure issues.
the .83 is a T4 and factory BW for the 68mm turbine. It will spool faster than the .91, but you can run into drive pressure issues. the .80 t3 is a better solution as it is wastegated so you can use a smaller turbine to spool up and then the wastegate opens to get 30-405 more flow out of the engine simulating a 1.10 housing thus keeping drive pressure low.
Drive pressure above 1.2: 1.0 boost will rob HP. thats why you want to tune the wastegate to open where ever the turbo compressors map is most efficient and flows the most air. Raising Boost pressure above that mark will actually flow less air with a greater restriction on both intake and exhaust = hotter air and more pumping losses.
Jacob
the .83 is a T4 and factory BW for the 68mm turbine. It will spool faster than the .91, but you can run into drive pressure issues. the .80 t3 is a better solution as it is wastegated so you can use a smaller turbine to spool up and then the wastegate opens to get 30-405 more flow out of the engine simulating a 1.10 housing thus keeping drive pressure low.
Drive pressure above 1.2: 1.0 boost will rob HP. thats why you want to tune the wastegate to open where ever the turbo compressors map is most efficient and flows the most air. Raising Boost pressure above that mark will actually flow less air with a greater restriction on both intake and exhaust = hotter air and more pumping losses.
Jacob