no bus after edge install p1687

Feb 9, 2014 | 10:09 PM

Share

#1

sixshooter

Thread Starter

|

Diesel Fan

Joined: Apr 2012

Posts: 89

Likes: 0

From: dayton ohio

no bus after edge install p1687

ok i installed a used edge cs today on my 01 cummins exactly how instructions said everything went good until i turned my lights on for a test drive and noticed i had no cluster lights,park lights,and brake lights truck started fine and ran perfectly fine so i checked engin bay fuse and park lamp fuse was blown so i replaced it and it blew as soon as i turned my lights on went through 5 or 6 15 amp fuses before they quit blowing but still no lights so i run diagnostics on the edge and the p1687 and i think a p1693 i erased the codes and cant remember for sure. any ideas whats going on no issues whatsoever before install and so far this is the only issue. i know p1687 is cluster but not sure what p1693 is or where to go from here

---AutoMerged DoublePost---

Quote:

Originally Posted by sixshooter

ok i installed a used edge cs today on my 01 cummins exactly how instructions said everything went good until i turned my lights on for a test drive and noticed i had no cluster lights,park lights,and brake lights truck started fine and ran perfectly fine so i checked engin bay fuse and park lamp fuse was blown so i replaced it and it blew as soon as i turned my lights on went through 5 or 6 15 amp fuses before they quit blowing but still no lights so i run diagnostics on the edge and the p1687 and i think a p1693 i erased the codes and cant remember for sure. any ideas whats going on no issues whatsoever before install and so far this is the only issue. i know p1687 is cluster but not sure what p1693 is or where to go from here

correction fuse still blows i had it in the wrong spot blows as soon as i turn my lights on. tested with a multimeter gettin 14v when truck is running.

Last edited by sixshooter; Feb 9, 2014 at 10:09 PM. Reason: Automerged Doublepost

Reply

0