ht3b,col and hot pipe
#1
ht3b,col and hot pipe
i have a chance to get everything i need to hook up to my hx35 to make twin turbos for 500 dollars ht3b has no shaft play at all everything looks solid and clean. with marine 370's afc ff #0 plate ff starwheel ff fuel screw ff foot and barrel cut 1/8 inch and washers swapped. wat hp should i be lookin at truck will be manual in the next week completed with a clutch to hold up if funds are right. 5 inch turbo back cold air intake
#2
#3
#4
ha ha not head studs im gonna set my psi at 35 so i dont blow up my little 35 and oringed head fire ringed head and done shaved the head and put the biggest gasket i could buy under it. one day im gonna flow my pump to 400cc then do delivery valves head studs at the same time........and gauges
#5
#7
no, he isn't saying that, he is only saying that your hx35 is capable of your 35psi goal. and with injectors and twins, guages are a must. its fine to run them as a twin setup. you should defenetly invest in guages first so you can monitor things, and from what i understand a retorqued head gasket stock can handle closer to 50psi but not sure i would trust it too long. personaly i would get the supporting mods ie guages, headstuds, possibly o-ring/firering the head, then injectors and twins so you wont have to worry latter
#8
Thread
Thread Starter
Forum
Replies
Last Post
j1004ss
Ford Powerstroke 03-07 6.0L
9
12-23-2021 02:59 PM
camp9
Ford 83-94 6.9 and 7.3L General
5
03-25-2017 07:40 AM
drsparkman
Chevy/GMC Truck and Duramax Turbo Diesel Forum
2
11-04-2015 10:32 AM
98suburbandiesel6.5l
Chevy/GMC 6.2L and 6.5L
4
07-25-2015 03:25 PM