Silencer ring
#21
#23
I would personally leave that alone and grab an aftermarket. Ive taken a look at mine and thought about using a circle bit to gut it but I dont want to chance cutting into the sides. It looks very time consuming as well.
#24
hole saw?
what would you need a hole saw for. i gutted my intake elbow very easily with a screwdriver and a pair of pliars. and all it took to get the silencer ring out (other than a nutdriver for the hose clamps on the intake) is a little flathead screwdriver and a pair of needlenose. if you take the whole intake assembly apart at each junction then you can slide the baffles right out. I actually messed up and popped the flange loose on one end but used red glue to put it back together and just to be safe sealed it on the outside with silicone. all in all took less than 45 min.
#26
Oh and it couldn't of been worse than this guys whistle.
Last edited by Youngblood; 12-14-2010 at 12:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post
CumminsAtYa
6.7 Liter Dodge Cummins 07.5-12
3
03-28-2015 06:36 PM