shouldnt be too hard, if you use a torch be careful how hot you get them... heard of a guy heating them up, beating on the lower one... shot the ball and stud out of the socket, took a chip out of the concrete and sounded like a shot gun going off, atleast that was his story... i've seen a mac truck parked at your house in your photos... borrow a ball joint press... and PB is well advised

 

Did mine about 5 months ago. HUGE pain in the ***. Snapped my Snap-On ball-joint press in half in the process . Took a healthy combination of another press, a lot of heat and liberal massaging with my 3lb BFH to get them out. I bought my MOOGs through Auto Parts Fast at RockAuto, who is one of our sponsors. WAY cheaper than any of the local parts emporiums like Auto Zone, Advance Auto or NAPA. Good luck.

 

Got my VOTE!

 

go for it steven danials cussed trying to do the ones in jeffs truck after i did the lift

 

I have moog on my truck. About 20k of hard miles on them with the 37's and they still hold up well! Not horribly more expensive than NAPAs also.

 

i just finish doing all four of mine the only pain was finding a good press dont use a cheap one i did and broke two of them finally got a good one from a local truck shop not cheap but worth the money other then that some heat and lots of pb blaster. i also put moog in and have always used them never any issues. o and an other thing if you have not replaced your tie rods good luck one of mine was bad and i had to do the upgrade because no one could get me any parts but it drives like a dream now.

 

What do you guys think of the rest of Federal Mogul products? Would you use their tie rods and such or are there better manufacturers of that stuff?