Problem communicating to the TCM
#1
Problem communicating to the TCM
Hi, I am new here. I have a 2003 dodge ram 3500 diesel, 5.9 cummins, 24 valve, with a 48 RE transmission. I had the transmission rebuilt last year with a stage 1 rebuild. I had to take it back due to shifting problems and random temp light on the trans, but the temp light does not stay on long. When they looked at it they said that they can't communicate with the TCM. My question is has anyone had/has this problem or possible troubleshooting things to due to figure out why? I think my ignition switch is going bad could that have anything to do with it? Thanks in advance for any advice.
#2
#4
#5
Same problem
I bought a used 03 ram 3500 5.9l that had the trans replaced. Shortly after buying it, it would stall when turning then starting going into limp mode. I would run a code reader and did the key thing to get codes that way as well. The code from the dash was always the p0700 code. After taking it different shops and getting no more. I swapped the tcm out with the one from my 97 ram 1500. I have a bad tcm. Now I am looking to either my tcm repaired or replaced.
Thread
Thread Starter
Forum
Replies
Last Post
CSIPSD
Ford Excursion 99-05 7.3L and 6.0L
2
04-13-2011 08:40 PM