heavy white smoke.........
#12
#13
Keep checking your coolant level. If the smoke is white as you say, it is water or condensation in your system. Might be a pin leak somewhere, hopefully not the block. VP44's need a fuel pressure guage more than anything. When starts to run at less than 14-16lbs the lift is going out and it is a lot cheaper than the injection pump. Once lift gone - there goes the injection pump.
#14
i have checked the fuel pressure at the schrader valve on
the injection pump and on the back of the filter/ water sep.
and i have 18 to 20 lbs of pressure and also i replaced the cheap
autozone filter with a new one from NAPA and i clean the iat and map
sensor and i put 2 stroke oil in fuel every other fill up
the white smoke stopped until a couple days ago then it started again
but as i was cleaning and replacing stuff i saw the top of the VP44 and it
read Remanufactured unit but have no idea how old it is tho.
the injection pump and on the back of the filter/ water sep.
and i have 18 to 20 lbs of pressure and also i replaced the cheap
autozone filter with a new one from NAPA and i clean the iat and map
sensor and i put 2 stroke oil in fuel every other fill up
the white smoke stopped until a couple days ago then it started again
but as i was cleaning and replacing stuff i saw the top of the VP44 and it
read Remanufactured unit but have no idea how old it is tho.
#15
#16
Thread
Thread Starter
Forum
Replies
Last Post
mattshow123
12 Valve 2nd Gen Dodge Cummins 94-98
14
03-12-2018 01:41 PM
wpg6.5
12 Valve 2nd Gen Dodge Cummins 94-98
7
03-22-2015 12:38 PM