Hey guys my transmission synchronizers are about shot I went to pull my tranny yesterday and I could not get my transmission to sepererate from my engine I've done these several times to change clutches and never seen anything like this I am just wondering if my pilot bearing could have gone out and welded itself to the input shaft or something I have a valair double disc... Any tips would be appreciated...

 

did you try just taking it out of the bellhousing vs all of it at once?

 

My input shaft was was stuck in my clutch discs i put my slave cylinder back on and pressed the pedal n it popped right out I tried what u said but it didn't make any difference

 

what was your clutch doing to make you change it i have one i cant get into gear and im thinking it the throw out bearing but i dont really know it just wont go into gear from a stop if it is shut off or rolling i can get it to go rite into any gear