Nv 4500 problem
Hey guys my transmission synchronizers are about shot I went to pull my tranny yesterday and I could not get my transmission to sepererate from my engine I've done these several times to change clutches and never seen anything like this I am just wondering if my pilot bearing could have gone out and welded itself to the input shaft or something I have a valair double disc... Any tips would be appreciated...
|
did you try just taking it out of the bellhousing vs all of it at once?
|
My input shaft was was stuck in my clutch discs i put my slave cylinder back on and pressed the pedal n it popped right out I tried what u said but it didn't make any difference
|
what was your clutch doing to make you change it i have one i cant get into gear and im thinking it the throw out bearing but i dont really know it just wont go into gear from a stop if it is shut off or rolling i can get it to go rite into any gear
|
All times are GMT -5. The time now is 12:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands