built an hx35/40 hybrid turbo, and put a new wastegate on it, it wasnt adjusted, i adjusted it to where i think it should be, and its putting out a solid 31lbs on the guage is that too high, too low, or just right? i also have a boost controller on it.

 

If it was me i would up it to 38-40psi.

 

Yea I am running 40 through a stock hx35. You caould go to 40. It doesnt look like you have studs so dont go over 40.

 

X2 40psi

 

ok ill turn the gate up some more then. also ive read before theres a company that makes a better flowing comp wheel for an hx40? right now i have the stock 6 blade in there out of the 40.

 

In level ten on my quad adr i have hit 41 psi with my stock hx-35, is that too much? i am a little nervous after reading this, i have only done a few times i usually leave it in level one.

 

41 is fine but try to save up for head studs. With head studs n stock gasket im running 52psi n doing just fine.