hx35/40 boost #?
 

built an hx35/40 hybrid turbo, and put a new wastegate on it, it wasnt adjusted, i adjusted it to where i think it should be, and its putting out a solid 31lbs on the guage is that too high, too low, or just right? i also have a boost controller on it.

If it was me i would up it to 38-40psi.

Yea I am running 40 through a stock hx35. You caould go to 40. It doesnt look like you have studs so dont go over 40.

X2 40psi :tu:

ok ill turn the gate up some more then. also ive read before theres a company that makes a better flowing comp wheel for an hx40? right now i have the stock 6 blade in there out of the 40.

In level ten on my quad adr i have hit 41 psi with my stock hx-35, is that too much? i am a little nervous after reading this, i have only done a few times i usually leave it in level one.

41 is fine but try to save up for head studs. With head studs n stock gasket im running 52psi n doing just fine.