NO BUS in odometer window
#11
#12
#13
yes sir
yea its known to happen thats why i said to check it, i know of a couple 1500 gaser dodges that have done it so i threw it out there same plug as the diesel and gas engines
#14
#15
Its possible its a ground. Or a module flaking out due to high moisture in its case. If it occurs and you can catch it, take it to a shop with a scope and do a loaded voltage test on the grounds for the instrument cluster. A good shop will have a recorded wave form of the bus system or they may record the wave form from a similar truck. It would allow you to see why the cluster isn't communicating by removing a module at a time. Its possible its the cluster itself. Are you able to communicate via dlc when the no bus is up on the odometer?
Sent from my DROID RAZR using Tapatalk 2
Sent from my DROID RAZR using Tapatalk 2
#16
i found mine after i had to put a stater in my truck it started then died, so i was messing with the pass side battery and the ground side had a broke connector so i replaced and i havnt had a low voltage to lift pump and no bus light like i did before the ground wire that goes for a smaller size to a plug then bigger to the ground post
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
05-05-2015 01:20 PM
Cody Cain
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-22-2014 01:27 PM
Cody Cain
Diesel In Distress - Support Ticket
0
12-21-2014 06:50 PM
wyoranch
5.9 Liter CR Dodge Cummins 03-07
1
10-28-2014 08:23 AM