Electrical help needed
#1
Electrical help needed
So, four days after the pump rebuild my truck has found another way to **** me off and kick me in the nuts. I was driving and then bam, nothing. It just shut off, lost dash lights, gauges froze, heater fan stopped running and then it wouldn't turn over, also no radio or wipers. So after a little reading and frustration I replaced the ignition switch.
Still nothing.
So here is what I am assuming since I lost this all at once: There is a feed from the battery to the igniton switch, from the switch power is fed to things like the FSS, dash, HVAC controls, wipers, radio, and of course starter. Does this sound correct? If so any ideas what color wire or fusable link I should be looking for? Don't have a service manual, haven't been able to find one, truck is a 93 W250. Thanks guys, this time maybe it will run for 5 days! honestly in one year of ownership and just 145k this truck has spent 6mos broke and 6mos running I thought they were reliable!
Still nothing.
So here is what I am assuming since I lost this all at once: There is a feed from the battery to the igniton switch, from the switch power is fed to things like the FSS, dash, HVAC controls, wipers, radio, and of course starter. Does this sound correct? If so any ideas what color wire or fusable link I should be looking for? Don't have a service manual, haven't been able to find one, truck is a 93 W250. Thanks guys, this time maybe it will run for 5 days! honestly in one year of ownership and just 145k this truck has spent 6mos broke and 6mos running I thought they were reliable!
#2
I'll look at my manual, till then i'd check the main +,- and start at the bat with a test light and work out.
---AutoMerged DoublePost---
did you learn anything today?
---AutoMerged DoublePost---
the ign switch is grounded through the steering column so start there. you'll have to get power from pos bat post. pull the 50 pin bulkhead off you should have power at 49 and 50 (top left battery side). those supply juice to a lot of crap. at least thats what it say in the book. word for word
---AutoMerged DoublePost---
did you learn anything today?
---AutoMerged DoublePost---
the ign switch is grounded through the steering column so start there. you'll have to get power from pos bat post. pull the 50 pin bulkhead off you should have power at 49 and 50 (top left battery side). those supply juice to a lot of crap. at least thats what it say in the book. word for word
Last edited by Balerdan; 01-07-2013 at 10:29 PM. Reason: Automerged Doublepost
#3
#4
Sounds like fuesable links but not all at one that would be odd. did your ground cable come loose anywhere. A lot of that stuff is not run to the ignition then to random stuff I just re wired a 85 crewcab which I copied a 90's harness very little is actually run to the ign switch directly.
#5
Thread
Thread Starter
Forum
Replies
Last Post
coryfast
Diesel In Distress - Support Ticket
2
07-06-2015 06:02 AM
Strictly Diesel
Strictly Diesel
0
06-30-2015 06:48 PM
Hmcyl
Diesel In Distress - Support Ticket
1
02-01-2015 04:18 PM