redneck way to set timeing?
#3
Yes there sorta is, but it is more complicated than using the tools. Depending on the pump you can set the lift by the clicks of a baring tool, I have used this to re-set a pump that kept jumping timing while we were trying to set it.
It is quite a bit easier to just buy yourself the timing kit and set it properly though.
It is quite a bit easier to just buy yourself the timing kit and set it properly though.
#5
#6
#7
I would not do it this way but I have heard this has been done:
It was described to me that you set TDC and push in the pin, pop the gear on the P-Pump and then pull the pin and roll the motor with the alt and put the gear back on. They claim that 1/8" move of the belt in reverese rotation will advace the timing 2*.
It was described to me that you set TDC and push in the pin, pop the gear on the P-Pump and then pull the pin and roll the motor with the alt and put the gear back on. They claim that 1/8" move of the belt in reverese rotation will advace the timing 2*.