i put the pin in the cam and the one in the pump.

 

How much lift do you have on number 1 plunger?

 

What do you mean? I let the number 1 piston come all the way to the top and when it started going down I turned it back up.

 

Here is the procedure - not exactly sure what you used:

TSB 18-10-94 Rev. A

Take note of the section at the end that describes how to check the timing.

 

I got the truck running. The pump was out of time, but now when you crank it it hardly idles and then it clears up.

 

Then you probably have to bump the idle up.

Glad to hear you got it running.

 

Thanks

 

Where can you buy the rubber hose that goes from the heater to the lift pump. The local dodge dealer said it was discontinued. I have tried to get some injector hose ,but it will bent and stop the fuel. Where can you buy a new one?

 

Where can you find afe dry filter for the cold air intake system for a 12 valve?

 

Any one of our sponsors will carry this filter Red...


You are looking for a AFE Prodry S or a AEM Dryflow. 4" inlet.

Are you looking for just a filter or for an intake?


I recently seen the intake with a Prodry filter for around $200