need pyrometer wiring not the probe I have that
#1
need pyrometer wiring not the probe I have that
I bought a set of gauges a while back from a guy and everything looked fine in the box. I pulled them out today because I am helping a fellow bomber out with a set for his truck. I look at the pyro and find all this electrical tape around where the wiring the yellow shielding with black and red wires inside.. it's been clipped and all jacked up. I have a spare probe just no wiring. So maybe someone has a wire setup out there? If that makes sense
#2
just use some normal like 18 or 16 gauge wire whatever size it was before. all it is is electrical wiring
---AutoMerged DoublePost---
the yellow shielding i believe is just like a protective heat shield stuff should be able to find it at any local auto store
---AutoMerged DoublePost---
the yellow shielding i believe is just like a protective heat shield stuff should be able to find it at any local auto store
Last edited by tltruckparts; 01-31-2010 at 09:25 PM. Reason: Automerged Doublepost
#4
nope it shouldnt. i hacked mine up, rerouted it and cut it to turn with my trucks interior, and it has never changed the slightest bit. length of wire will not add any resistance at all. all the probe is is a resister that changes with heat same way a water or oil temp gauge will work. just make sure its heat wrapped where it matters, and other than that, its just wire. hope that helps
Thread
Thread Starter
Forum
Replies
Last Post
Mike H
12 Valve 2nd Gen Dodge Cummins 94-98
1
11-25-2014 03:13 PM