Project Resurection P-Pump
#91
07-01-2010, 10:12 PM
When are you sending the 12v down? 
#92
07-02-2010, 01:02 AM
The following users liked this post:
Red_Rattler (07-02-2010)
#93
07-02-2010, 05:51 AM
Diesel Enthusiast
The following users liked this post:
Red_Rattler (07-02-2010)
#94
07-02-2010, 07:07 AM
Diesel Bomber
I saw a BEARS sticker on the garage door at the paint shop 
The following users liked this post:
Red_Rattler (07-02-2010)
#95
07-02-2010, 08:06 AM
Diesel Fan
The following users liked this post:
Red_Rattler (07-02-2010)
#96
07-02-2010, 03:04 PM
The following users liked this post:
Red_Rattler (07-02-2010)
#97
07-13-2010, 09:32 PM
The following users liked this post:
Red_Rattler (07-14-2010)
#98
07-13-2010, 09:36 PM
The following users liked this post:
Red_Rattler (07-14-2010)
#99
07-14-2010, 02:14 PM
The following users liked this post:
Red_Rattler (07-14-2010)
#100
07-14-2010, 06:22 PM
Progress slowed alil bit since I've been out drivin it around now but, I have added a couple new things and most noticable is the 7" rolled tip stack! 
6 inch hole saw is the ONLY way to do it imo...
Great clamp from GrandRock but o had to mod it so the bolts were able to come into the bracket so I could tightent it. No big deal, 4 spot welds to cut holding the bolt and pound them out with a hammer.
My temp. rain cal till I buy a stack condom
New licence plat light till I get a roll pan
6 inch hole saw is the ONLY way to do it imo...
Great clamp from GrandRock but o had to mod it so the bolts were able to come into the bracket so I could tightent it. No big deal, 4 spot welds to cut holding the bolt and pound them out with a hammer.
My temp. rain cal till I buy a stack condom
New licence plat light till I get a roll pan
Last edited by Red_Rattler; 07-14-2010 at 06:31 PM.
