Loss of All power and speedo maxxed out. NO CODES
Thread Starter
|
Diesel Enthusiast
Joined: Jan 2010
Posts: 129
Likes: 7
From: Kansas
can the ECM be cleared or would it need replacing?
I think i'll just start by clearing some of this wire mess up. I should probably find a back up car for a little while as i probably wont get it all back together very quickly
I think i'll just start by clearing some of this wire mess up. I should probably find a back up car for a little while as i probably wont get it all back together very quickly
Bombardier
Joined: Mar 2007
Posts: 9,655
Likes: 607
From: Da' Dirty South
i would judt check for codes, clear them and see what codes return. this will help narrow down the problem. if there anre no codes then it might be something else.
also make sure that the plug into the ECM / Computer is good and clean, use Di-Electric grease on the pins and make sure there is no corrosion.
also make sure that the plug into the ECM / Computer is good and clean, use Di-Electric grease on the pins and make sure there is no corrosion.
Thread Starter
|
Diesel Enthusiast
Joined: Jan 2010
Posts: 129
Likes: 7
From: Kansas
will a basic ODB code reader pick up our codes? Autozone $60
---AutoMerged DoublePost---
So far I have pulled out old strobe lights and controller, an air horn regulator, and a PA speaker. All with dead end wires.
---AutoMerged DoublePost---
So far I have pulled out old strobe lights and controller, an air horn regulator, and a PA speaker. All with dead end wires.
Last edited by gixxertricks; Sep 17, 2010 at 08:25 PM. Reason: Automerged Doublepost
