95 F350 front axle u-joints
#1
#4
pull the wheel off, then the 4wd hub. there are 2 spanner nuts in there. in between them is a washer with a key and a bunch of holes in it. the second spanner nut has a smal pin, do not break that off. then pull the whole hub off. 5 bolts hold the spindle on. the back side of the spindle is a press- on fit to the knuckle. lay a block of wood on the spindle and hit it side to side and work it off. when you get that off the axle slides out. since you have to do the inner seals as well, pull the drive shaft and the yoke. then pull the diff cover off and then pull the carrier. the inner seals are a light press- on fit in the housing and on to the axle shaft. then reverse all the steps. when you put the axles back in, make sure they are lubed up good so you don't knock the seals out out.
#6
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
0
11-21-2014 01:11 PM
1ATony
1A Auto Parts
0
11-21-2014 12:36 PM