:( oil pan
#1
:( oil pan
Anybody ever done an oil pan in one of these? i think i punctured it while changing engine mounts. its 4x4 btw
---AutoMerged DoublePost---
also anybody know about a gasket? Advance and auto zone dont have them and alldata is tellin me to use a ford sealant. So does somebody make a gasket at all or just rtv basically?
---AutoMerged DoublePost---
also anybody know about a gasket? Advance and auto zone dont have them and alldata is tellin me to use a ford sealant. So does somebody make a gasket at all or just rtv basically?
Last edited by prison; 07-06-2011 at 01:10 AM. Reason: Automerged Doublepost
#2
Anybody ever done an oil pan in one of these? i think i punctured it while changing engine mounts. its 4x4 btw
---AutoMerged DoublePost---
also anybody know about a gasket? Advance and auto zone dont have them and alldata is tellin me to use a ford sealant. So does somebody make a gasket at all or just rtv basically?
---AutoMerged DoublePost---
also anybody know about a gasket? Advance and auto zone dont have them and alldata is tellin me to use a ford sealant. So does somebody make a gasket at all or just rtv basically?
Pull motor, put it on a stand and flip upside down. Remove pan, clean old "black death" off and prep for new pan. Run a line of "black death" around everything and install pan. Leave upside down for at least 12 hours. Reinstall motor (flip it right side up...)
FYI... Black Death is the factory Ford RVT. Go to ford and ask for it. DO NOT USE ANYTHING else unless you want to do it again in the near future.
#3
#4
It can not be done in the truck without removing the riveted in cross member. And its very difficult to flip the truck upside down anyway.
Harbor freight sells a stand that you can use to flip the motor.
#5
well from monitoring it over the course of night and day im not positive its an oil leak. this pan has almost an rtv type coating on the majority of it or maybe its grease and i'm wondering if the pbblaster i sprayed didnt get down there and eat some of it and make it drip. i have a stand from harbor freight that my 6.9 is currently on and man it doesnt roll well or even turn that engine well so i have severe doubts about putting a powerstroke on it. have you used one or do you know of one that is made a little heavier?
---AutoMerged DoublePost---
oh are you talking about there red 2k pound stand? i have a 1000. they didnt have the 2000 when i bought mine
---AutoMerged DoublePost---
oh are you talking about there red 2k pound stand? i have a 1000. they didnt have the 2000 when i bought mine
Last edited by prison; 07-06-2011 at 06:33 PM. Reason: Automerged Doublepost
#6
#8
Thread
Thread Starter
Forum
Replies
Last Post