clutch wont fully release
#1
clutch wont fully release
Hello All,
I have a 95 f350 powerstroke. Throw out bearing went out so replaced clutch, bearing and pressure plate and all worked fine for over a month. Then one morning while going to work the clutch stopped releasing all the way. I then replaced master cylinder, slave cylinder with a new assy preloaded but no change. I then adjusted the arm under the dash to put more pressure on the slave cylinder but no change. I pulled the tranny and pressure plate and found that the fingers are 1/4 higher than another that I have that also came off of a powerstroke. The hole where the shaft goes through is also 1/4 larger. Could the fingers being higher cause the issue with the clutch not releasing. I am not new to diesels but learning about the 7.3 powerstroke.
I have a 95 f350 powerstroke. Throw out bearing went out so replaced clutch, bearing and pressure plate and all worked fine for over a month. Then one morning while going to work the clutch stopped releasing all the way. I then replaced master cylinder, slave cylinder with a new assy preloaded but no change. I then adjusted the arm under the dash to put more pressure on the slave cylinder but no change. I pulled the tranny and pressure plate and found that the fingers are 1/4 higher than another that I have that also came off of a powerstroke. The hole where the shaft goes through is also 1/4 larger. Could the fingers being higher cause the issue with the clutch not releasing. I am not new to diesels but learning about the 7.3 powerstroke.
#2
Thread
Thread Starter
Forum
Replies
Last Post
Turbo67
Dodge Truck and Cummins Turbo Diesel Forum
0
07-25-2015 02:26 PM