Getting ready to install my DIESELSITE Coolant Filter
#1
Getting ready to install my DIESELSITE Coolant Filter
so im getting ready to install and i was wondering on the refill of coolant.. Do i put in 3 or 4 gal of coolant and top off with water?? my truck is a 05 f350.. anyone help me out.. thanks!!
Last edited by pushingmy6.0; 09-22-2010 at 07:08 PM.
#2
#4
#6
6.0L Coolant Flush Procedure
Here is what you do.... (I do it every 50,000 miles just because it is fun to do and I am **** about my maintenance).
1) Buy 4 gallons of Ford Premium Gold coolant at dealer
2) Buy 15 gallons of distilled water at local grocery store.
3) Drop lower radiator hose until empty.
4) Reconnect hose and add distilled water to degas bottle until full.
5) Drive truck until temp gauge goes to normal and thermostat opens.
6) Repeat steps #3 through #5 no less than 4 or 5 times (depends on distilled water amount used) - I can't remember?
7) You now have 100% distilled water in your system.
8) Drop lower hose 1 last time, drain and reconnect.
9) Look in manual for your system capacity and for a 50/50% refill of coolant just add the coolant straight into your degas bottle up to the amount that equals a 50/50% concentration.
10) Start motor and add distilled water to bring system level to the MIN mark on degas bottle.
11) Drive truck around to open thermostat and let cool 1 or twice to purge any air. May need to add more distilled water (don't add coolant)... but when done you have flushed your entire system and have a perfect 50/50% concentration of coolant and distilled water!!!!
Here is what you do.... (I do it every 50,000 miles just because it is fun to do and I am **** about my maintenance).
1) Buy 4 gallons of Ford Premium Gold coolant at dealer
2) Buy 15 gallons of distilled water at local grocery store.
3) Drop lower radiator hose until empty.
4) Reconnect hose and add distilled water to degas bottle until full.
5) Drive truck until temp gauge goes to normal and thermostat opens.
6) Repeat steps #3 through #5 no less than 4 or 5 times (depends on distilled water amount used) - I can't remember?
7) You now have 100% distilled water in your system.
8) Drop lower hose 1 last time, drain and reconnect.
9) Look in manual for your system capacity and for a 50/50% refill of coolant just add the coolant straight into your degas bottle up to the amount that equals a 50/50% concentration.
10) Start motor and add distilled water to bring system level to the MIN mark on degas bottle.
11) Drive truck around to open thermostat and let cool 1 or twice to purge any air. May need to add more distilled water (don't add coolant)... but when done you have flushed your entire system and have a perfect 50/50% concentration of coolant and distilled water!!!!
Thread
Thread Starter
Forum
Replies
Last Post
caissiel
Ford Powerstroke 03-07 6.0L
1
09-24-2015 05:37 PM