6.0 siren
#1
#2
#3
I have checked the inlet all looks good. Seems to be normal play in the shaft. It still runs good turbo seems to be vibrating. I havent checked exhaust side can a turbo blade break off? its like its out of balance. I have a AFE filter,Exhaust and superchip flash pac on performance. Thank you, Larry
#5
The noise sounds like it follows boost and when I shut it off you can hear it wind down. Like I said it also vibrates pretty bad I think. What could damage it? My son was towing a boat up a hill when he said it started and pyro never was over 800 deg. So he says. I have been told the bellows pipes crack in back of the turbo and can do this also. what do you think? Larry
#6
Checkthe up-pipes out REALLY WELL for cracks. I had one crack on my truck at about 55k miles, out of the blue. It whistled extremely loud when I first started the truck to the point it sounded like it was literally screaming. I never lost boost though. I agree, check them out.
Might want to look into a different programmer too, but you'll realize that if you just read around here a little more.
Might want to look into a different programmer too, but you'll realize that if you just read around here a little more.
#7
Thread
Thread Starter
Forum
Replies
Last Post
BeastFromTheEast
Diesel Bombers Introduction
6
08-04-2015 10:06 AM
thumperf350
Ford Powerstroke 03-07 6.0L
4
01-08-2015 12:55 AM