no start issue, again!
#1
#4
If you are not seeing anything on dash guage then that is low pressure oil for the motor, the high pressure pump is seperate and there is no guage for it. You can check the low pressurepump by pulling the cap off the filter then hold down the little plunger at bottom of filter housing then have someone crank it over to see if the housing fills up with oil, you can use a long screwdriver to hold down the plunger or pop the filter off the cap and hold the filter down in th housing to test it.
Now it is also very common for the IPR screen to get glogged after a HPOP install which can also cause these issues, simply remove IPR and clean screen or replace SCREEN if it is damaged. replacement screens are alot cheaper then a whole valve.
Now it is also very common for the IPR screen to get glogged after a HPOP install which can also cause these issues, simply remove IPR and clean screen or replace SCREEN if it is damaged. replacement screens are alot cheaper then a whole valve.
Thread
Thread Starter
Forum
Replies
Last Post
Cavnar
Diesel In Distress - Support Ticket
3
09-09-2015 07:18 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
Cumminsfummins
Ford Powerstroke 08-10 6.4L
2
01-26-2015 08:11 AM