Tools fall inside the cylinder .
#21
#22
I still can't get my engine start up. I didn't crank no longer than 20 sec.. I am worry to burn out the starter.. Shall I crank for a minute to see if it build up?
I feel like it doesn't get any fuel into the injectors at all.
I get engine oil pressure read on the gauge. But I don't get any pressure read on my ICP? could that be because of ICP is bad?
Here is a screenshot from a OBDII.
I plan to drop off my oil pan today to see if those head screws are there.
I feel like it doesn't get any fuel into the injectors at all.
I get engine oil pressure read on the gauge. But I don't get any pressure read on my ICP? could that be because of ICP is bad?
Here is a screenshot from a OBDII.
I plan to drop off my oil pan today to see if those head screws are there.
Last edited by saranay; 08-18-2012 at 02:13 PM.
#23
#24
which oil rails do you have? the straight log type or the pretzel type? if it's the pretzel type did you install a new standpipe and dummy plug while you were in there? Also check to mke sure the butterfly valve is open under the intake elbow, they won't run without air.
No, but I checked the seals are still in a good condition no burrs or frayed and I only changed the injectors one side of passenger.
yes, i have butterfly valve on full open.
Right now I will attempt to do a long 1 minute crank to see if I get any pressure is building up on ICP sensor.
#25
#27
Thread
Thread Starter
Forum
Replies
Last Post
Kennyw250
1st Generation Dodge Cummins 89-93
3
01-14-2015 07:47 PM
Diesel Bombers
General Diesel Related
0
10-31-2014 08:10 AM