Air Dog Install With Pics
#1
Air Dog Install With Pics
Okay got my Air Dog 150 and after a chat with Charlie got to work.
First off, if you have a short bed then you gonna need a different bracket.
Here is the one that come with the kit
and this is the one I needed
Starting with these two fittings
and this is the thread paste I used
got all the fittings installed
First off, if you have a short bed then you gonna need a different bracket.
Here is the one that come with the kit
and this is the one I needed
Starting with these two fittings
and this is the thread paste I used
got all the fittings installed
Last edited by Dr. Evil; 03-20-2008 at 09:45 PM.
The following users liked this post:
Nitelord (03-21-2008)
#2
Here is the vp44 with the banjo bolt removed and the new fitting installed
once I got the line ran from the Air Dog to the vp44 it was time to drop the tank(not as bad as you would think)
I didn't follow the directions for the placement of the draw straw this is where I put mine
This by the way is a 1 1/8" hole
and this is how I ran the hose
I cut the straw about 1/8 off the bottom at a angle
once I got the line ran from the Air Dog to the vp44 it was time to drop the tank(not as bad as you would think)
I didn't follow the directions for the placement of the draw straw this is where I put mine
This by the way is a 1 1/8" hole
and this is how I ran the hose
I cut the straw about 1/8 off the bottom at a angle
Last edited by Dr. Evil; 03-20-2008 at 09:48 PM.
The following users liked this post:
Nitelord (03-21-2008)
#3
Here is the return line and draw straw and factory pump installed and ready to put the tank back up
with the tank installed this is how the lines were ran
here is everything hooked up and ready for wiring
ran the wires and hose along the frame
Now all I have to do is hook up the wiring harness I'll get some pics of that tomorrow
with the tank installed this is how the lines were ran
here is everything hooked up and ready for wiring
ran the wires and hose along the frame
Now all I have to do is hook up the wiring harness I'll get some pics of that tomorrow
Last edited by Dr. Evil; 03-20-2008 at 09:50 PM.
The following 2 users liked this post by Dirtygrunt:
Coal_Roller (03-20-2009),
Nitelord (03-21-2008)
#6
#7
Sure is a lot of trash in that fuel. Hope you drained all that out before reinstalling the tank. Nice write up by the way.