Where are the shims located exactly?

 

Under the injection pump.

 

Under the injector tubes? Do you get to them from the top cover of the pump? Sorry to hijack this thread but I read something about the shims on another thread and couldn't find it again.

 

Yes, remove the top cover of the pump.

 

Got the crank and water pump pullys made and soldiered some flair fittings on the banjo fuel fittings for a hard line

 

Nice lookin set up. Are you building brackets or are you going with an accessory plate. I bought 2 aluminum sbc waterpump pulleys and I'm building a plate to mount everything on. Pulled my crank hub off tonight and machining it down to 1/4" flange thickness. The nut will hold the pulley and hub in place and I will either bolt or pin the pulley to keep it from spinning on the shaft.

 

Thanks FTE

 

Looking good! Nice pulleys.

 

I will probably build brackets just because i like the style more then just a plate and i will probably build them from aluminum like my first swap but i have a power steering pump this time

 

Finally starting on the truck up on stands all of the old suspension out and both new axles. put lockers in both and new cv axles and hub bearings in the front