|
Originally Posted by spencxr80
(Post 1111536)
Before I found out about the shims I have already pulled the front case off and advanced the pump cam one tooth witch will give me about 6deg I wish I knew about the shims it would have been way easier
|
Originally Posted by Freedom92
(Post 1112184)
Where are the shims located exactly?
|
Originally Posted by FTE
(Post 1112194)
Under the injection pump.
|
Originally Posted by Freedom92
(Post 1112219)
Under the injector tubes? Do you get to them from the top cover of the pump? Sorry to hijack this thread but I read something about the shims on another thread and couldn't find it again.
|
Got the crank and water pump pullys made and soldiered some flair fittings on the banjo fuel fittings for a hard line
https://cimg5.ibsrv.net/gimg/www.die...edc380aa83.jpg https://cimg7.ibsrv.net/gimg/www.die...af2c0a93be.jpg https://cimg5.ibsrv.net/gimg/www.die...11f9c1a2cd.jpg https://cimg3.ibsrv.net/gimg/www.die...1f96e8712a.jpg |
Nice lookin set up. Are you building brackets or are you going with an accessory plate. I bought 2 aluminum sbc waterpump pulleys and I'm building a plate to mount everything on. Pulled my crank hub off tonight and machining it down to 1/4" flange thickness. The nut will hold the pulley and hub in place and I will either bolt or pin the pulley to keep it from spinning on the shaft.
|
Originally Posted by FTE
(Post 1112252)
Yes, remove the top cover of the pump.
|
Looking good! Nice pulleys.
|
Originally Posted by Freedom92
(Post 1112273)
Nice lookin set up. Are you building brackets or are you going with an accessory plate. I bought 2 aluminum sbc waterpump pulleys and I'm building a plate to mount everything on. Pulled my crank hub off tonight and machining it down to 1/4" flange thickness. The nut will hold the pulley and hub in place and I will either bolt or pin the pulley to keep it from spinning on the shaft.
|
Finally starting on the truck up on stands all of the old suspension out and both new axles. put lockers in both and new cv axles and hub bearings in the front
https://cimg4.ibsrv.net/gimg/www.die...782196210c.jpg https://cimg9.ibsrv.net/gimg/www.die...fc86a43f90.jpg https://cimg0.ibsrv.net/gimg/www.die...fe026009ae.jpg https://cimg4.ibsrv.net/gimg/www.die...924dd870b1.jpg |
| All times are GMT -5. The time now is 09:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands