Question on Trans removal
#1
Question on Trans removal
In the middle of pulling my trans to replace the converter (smoked the lockup clutch).
It's been a few years since I have had one out. Does the starter need to come off to get to the converter bolts?? I vaguely remember a plate that needed to be removed but I can't find it.
FSM doesn't say, though as usually it's about worthless. Talks about V6 stuff in teh 47RE section. When was the last time V6 came with a 47RE????
It's been a few years since I have had one out. Does the starter need to come off to get to the converter bolts?? I vaguely remember a plate that needed to be removed but I can't find it.
FSM doesn't say, though as usually it's about worthless. Talks about V6 stuff in teh 47RE section. When was the last time V6 came with a 47RE????
#2
https://www.dieselbombers.com/12-val...anny-swap.html check out what dazedandconfused has to say about removing the tranny hopefully it will help
#3
There should be a plate on the passenger side facing toward the front, at the rear of the engine. Two bolts and it comes off.
Last edited by Cain379; 07-22-2010 at 03:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Bigredpowerstroke
Ford 83-94 6.9 and 7.3L General
1
12-19-2014 05:18 PM