need to know how to set overhead and torques for rocker bridge and injector adjustment on a n14 celect cummins, also jake bridge torque engine serial number 11998974 525 hp

---AutoMerged DoublePost---

n14 celect cummins 525hp

 

On the Celect,you adjust valves & inj on same cyl.The mark A is now 1-6,B is 2-5, & C is 3-4.Valves are Int 0.014 & Exhaust is 0.027.The injector you hand tighten screw until injector plunger bottoms out.Back screw out 2 flats,ie turn corner of lock nut to align with the riviot in the rocker lever(pushtube side),then back out screw two "corners" then tighten the jam nut down.Adjust the Injector first,then the valves. The C Brakes lash is 0.023.
looked around and found this hope it might help and welcome to diesel bombers

 

nice...