n14 celect cummins 525hp
#1
n14 celect cummins 525hp
need to know how to set overhead and torques for rocker bridge and injector adjustment on a n14 celect cummins, also jake bridge torque engine serial number 11998974 525 hp
---AutoMerged DoublePost---
n14 celect cummins 525hp
---AutoMerged DoublePost---
n14 celect cummins 525hp
Last edited by GWILLIAMS; 02-08-2010 at 12:31 PM. Reason: Automerged Doublepost
#2
On the Celect,you adjust valves & inj on same cyl.The mark A is now 1-6,B is 2-5, & C is 3-4.Valves are Int 0.014 & Exhaust is 0.027.The injector you hand tighten screw until injector plunger bottoms out.Back screw out 2 flats,ie turn corner of lock nut to align with the riviot in the rocker lever(pushtube side),then back out screw two "corners" then tighten the jam nut down.Adjust the Injector first,then the valves. The C Brakes lash is 0.023.
looked around and found this hope it might help and welcome to diesel bombers
looked around and found this hope it might help and welcome to diesel bombers
The following users liked this post:
captain_stabbin (02-08-2010)
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
General Diesel Related
0
10-31-2014 08:10 AM
Diesel Bombers
General Diesel Related
0
10-24-2014 04:40 AM
Omingnome
Diesel In Distress - Support Ticket
5
10-20-2014 12:25 PM
Diesel Bombers
General Diesel Related
0
10-20-2014 08:10 AM