2003 cummins won't start HELP please !
#1
2003 cummins won't start HELP please !
I just purchased a 2003 dodge cummins 5 spd I replace two injectors on it cause they were leaking and still the truck won't crank up unless you use starting fluid. Once started the truck runs , idles, and reves fine any help would be greatly appriciate. Thanks
#2
welcome to diesel bombers a great place to hang out and check this out and see if it will help https://www.dieselbombers.com/diesel...ont-start.html
#3
My experience with the CR engines has been that if the truck won't start, it's almost always an injector issue. Has been with me at any rate. Changed more than 10 injectors on the '05 to date...
Hope the link provided by ArizonaRedneck is of assistance.
#5
Ok well we tighted all the nuts all the lines and the truck started right up 5 times then boom now the truck won't start again ......... What the heck is goin on any help please
#6
Explain by what was leaking? Also did the connector tubes get properly seated and torqued down correctly?
#9
When u first install the injector you tighten it down to 44 inch pounds then back off the bolts to seat it, then install the connector tubes ***** up and tighten it to 11 ft lbs. Then tighten the injector to 89 inch lbs then retorque the tubes to 37 ftlbs. Then when putting the lines back on use a wrench on the tube and line so you don't effect the torque on the tube. Also did you inspect the tubes while they were out for and deforms or defects? Cummins suggests replacing them when u replace the injector but it's not nessecery. Hope this helps
Last edited by Red_Rattler; 01-25-2010 at 08:10 PM.
The following users liked this post:
Whit (01-26-2010)