just replace the sensor then goto dealer, if its under recall and you can sweet talk the service dept. they might write it up and give you the part for a spare. if not just have them replace it and then request to keep your old part. at least where im at they will do this. and ford/parts do not call back old part, they go in the trash. p.s. you will need a spare in future. just put it and a wrench in the glove box.

 

Ok guys I am going to head to Auto zone soon and get the OBD-II scanner and see what i can get with it if it can't bring anything useful up i might just replace the cps and go from there. I just want it to run so I can take to my buddies shop and start fixing it. Like I have said before you guys are better than going to the dealer for answers atleast I get an honest one from everyone who has replied. And thanks for the INFO.
i will get back soon with my results.

 

Im coming down tonight , i can bring my scanner , Get a CPS if your going to autozone

 

k guys scanned the shuttle bus got a pass on codes went a head and bought the cps and going to install as soon as the weather lets up a little better.

 

Good Luck kirk

 

how goes it

 

Any luck yet??

 

Ford will reimburse you for a cam sensor and any necessary labour/diagnostic costs associated with the repair if you need to replace it at another facility, or it was replaced before the recall came out.

 

ok well update so far new cps white smoke if it does start sounds like a two cyl diesel in the winter trying to run and then dies and killed my bats so need to charge them back up and get it to flash lights so i can take it to a shop to check it out. But on the other hand i finally got the part in wasnt very fun to get to ended up pulling the belt off and barely getting my hand up in there to get to the part even though its only one bolt damn is it hard to get to laying on the ground but thanks again on all of you who have helped me out.

 

Let us know what the shop finds out.