Need some help.
#21
#22
go buy about 2 feet of 1/4 rubber hose and you can loop the line around enough to fit the whole thing on there, i was able to fit mine with a straight shot with the tap and boost valve but it was a tight fit.
ill show ya a pic of my FP tap when its sunny out, there was no room to fit the tee in a straight shot so i just got extra hose and did a loop with the hose to get it all in there.
ill show ya a pic of my FP tap when its sunny out, there was no room to fit the tee in a straight shot so i just got extra hose and did a loop with the hose to get it all in there.
#24
#26
#29
My wastegate is taking its pressure reading from the actual boost pressure going into the engine, there is like a 2 psi drop going through the intercooler, if you were to tap ur boost gauge after the IC it would read lower.
Im doing some testing right now, since the WG is sensing less boost later the WG will stay closed longer and boost will build up quicker. ive aready seen a 2psi gain over stock with just that mod, and boost will spike quicker too.
#30
My wastegate is taking its pressure reading from the actual boost pressure going into the engine, there is like a 2 psi drop going through the intercooler, if you were to tap ur boost gauge after the IC it would read lower.
Im doing some testing right now, since the WG is sensing less boost later the WG will stay closed longer and boost will build up quicker. ive aready seen a 2psi gain over stock with just that mod, and boost will spike quicker too.
Im doing some testing right now, since the WG is sensing less boost later the WG will stay closed longer and boost will build up quicker. ive aready seen a 2psi gain over stock with just that mod, and boost will spike quicker too.
but normally i don't see over 23psi.