limped then wouldnt move..
#1
limped then wouldnt move..
took off in my 01 duramax today, and it instantly trans limped for some reason,...
just did spin on 2 days ago.
pulled over and shut the truck off to let it reset. then it wouldn't move in any gear.... the gear indicator would just flash on each gear..
only way i got it goin again was disconnecting batteries.
took off fine after that and a mile down the road the codes turned themselves off???
went on a 100 mile round trip right after and had no problems..
and ideas?
neutral safety?
just did spin on 2 days ago.
pulled over and shut the truck off to let it reset. then it wouldn't move in any gear.... the gear indicator would just flash on each gear..
only way i got it goin again was disconnecting batteries.
took off fine after that and a mile down the road the codes turned themselves off???
went on a 100 mile round trip right after and had no problems..
and ideas?
neutral safety?
#2
#3
thats what i was thinking. couldnt figure out what else would have made it limp as i was on level three on the juice and have a triple-lok.
---AutoMerged DoublePost---
ok read codes at work today and got P0847 Trans fuild pressure sensor B. and 2 pending p0700 trans control..
anyone help me with what the next step should be?
---AutoMerged DoublePost---
ok read codes at work today and got P0847 Trans fuild pressure sensor B. and 2 pending p0700 trans control..
anyone help me with what the next step should be?
Last edited by MI-Duramax-Boy; 06-17-2010 at 12:54 PM. Reason: Automerged Doublepost
#4
what kind of spin-on filter did you use?
Did you do an internal as well?
Possible - incorrect filter used for the spin-on. Possible - internal filter not properly installed or fell out a little. ( i know you just mentioned spin-on but figured this would help as well)
Hows the fluid level ?
Did you do an internal as well?
Possible - incorrect filter used for the spin-on. Possible - internal filter not properly installed or fell out a little. ( i know you just mentioned spin-on but figured this would help as well)
Hows the fluid level ?
#5
#6
what kind of spin-on filter did you use?
Did you do an internal as well?
Possible - incorrect filter used for the spin-on. Possible - internal filter not properly installed or fell out a little. ( i know you just mentioned spin-on but figured this would help as well)
Hows the fluid level ?
Did you do an internal as well?
Possible - incorrect filter used for the spin-on. Possible - internal filter not properly installed or fell out a little. ( i know you just mentioned spin-on but figured this would help as well)
Hows the fluid level ?
spin on was a champion Labs.
went on perfect, no leaks anywhere.
fluid level looks fine...
think i should drain it and do an internal now also?
Thread
Thread Starter
Forum
Replies
Last Post
Walker.B
Chevy/GMC Duramax 01-04 LB7
8
11-12-2015 09:00 PM
twwtruck
12 Valve 2nd Gen Dodge Cummins 94-98
19
04-07-2015 05:14 PM
cdpowers
5.9 Liter CR Dodge Cummins 03-07
6
01-23-2015 01:42 PM