No turn signal or hazards after multifunction switch swap
#1
No turn signal or hazards after multifunction switch swap
Hi, everyone.
Apologies if this is answered elsewhere, but I can't seem to find any precise answers. My turn signals and hazards were working intermittently; working the hazards button on and off repeatedly seemed to help. I replaced the multifunction switch, and now I have no turn signal or hazard illumination at all, but the wipers work (I haven't taken it out yet to see if cruise works too). I've got a combo flasher relay on order but am wondering if there's anything else I should look at. The fuses are fine. Thanks in advance.
Apologies if this is answered elsewhere, but I can't seem to find any precise answers. My turn signals and hazards were working intermittently; working the hazards button on and off repeatedly seemed to help. I replaced the multifunction switch, and now I have no turn signal or hazard illumination at all, but the wipers work (I haven't taken it out yet to see if cruise works too). I've got a combo flasher relay on order but am wondering if there's anything else I should look at. The fuses are fine. Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
JBearSVT
12 Valve 2nd Gen Dodge Cummins 94-98
6
08-22-2016 05:38 PM
Gizmo52
1st Generation Dodge Cummins 89-93
0
01-06-2015 11:58 AM