6.5L Timing after Max-E-Tork
#1
6.5L Timing after Max-E-Tork
Hey guys. Long time no see! Well, i have a problem, and knew there was no better place to run to for advice then Dieselbombers. Today i installed my turbomaster and max-e-tork, into my 1999 k2500. After both were done, i did the Injection Pump Learn Procedure that was part of the instructions provided by Heath. After that, started it up, and it ran great! Took it around the block a few times to get it up to 170 degrees like the instructions said. All was going sooooo well! Once i got home, i shut it down, and went inside. A little bit later, my roommate asks if i will go up and get dinner, and i said sure. Went outside and started the truck, and it was idling at about 1500 rpms, and throwing an injection pump timing code.
Any word of advice? I would call Heath Diesel, but they are closed. Really hoping to get this going before work at 7am tomorrow!
Any word of advice? I would call Heath Diesel, but they are closed. Really hoping to get this going before work at 7am tomorrow!
#2
Thread
Thread Starter
Forum
Replies
Last Post
quiksilver1j
1st Generation Dodge Cummins 89-93
1
07-30-2015 12:41 PM